OXFORD ACTIVECAL PC | Light Cure Resin-reinforced MTA Pulp Capping Material

Description

Descreption :

Oxford ActiveCal PC is a light-cure resin reinforced pulp capping material with MTA-fillers, designed to perform as a barrier and to protect the pulp. Thanks to its thixotropic behavior and with the supplied NeedleTip Oxford ActiveCal PC can be applied very precisely, even in deep cavity preparations. Light cure of Oxford ActiveCal PC ensures controlled setting.

Indications
1. Direct pulp capping for any pulpal exposures, including: carious pulp exposure mechanical pulp exposure pulp exposures due to trauma
2. Indirect pulp capping agent in deep preparations: under amalgam restorations under Class I and Class II composite restorations under cements as an alternative to calcium hydroxide

Application
Screw off the cap of the syringe and substitute it by a NeedleTip. Store the screw cap!

1. Direct pulp capping for any pulpal exposures

1.1. Cavity Preparation
After isolation (best with a rubber dam) prepare the cavity.
First achieve hemostasis by placing a sterile cotton pellet dampened with sterile saline gently onto the exposure site. Then remove excess moisture with a sterile cotton pellet. Leave the surface visibly moist.

1.2. Application
Apply Oxford ActiveCal PC directly to the exposed pulp. In case of layers more than 1 mm cure each layer separately.
Cover all the exposed areas with Oxford ActiveCal PC. If desired extend Oxford ActiveCal PC not more than 1 mm onto dentine surrounding the exposure.
Due to the high opacity of Oxford ActiveCal PC light cure each increment 40 seconds by using a polymerization unit (wavelength range 400-500 nm) with a light intensity of at least 1000mW/cm2.
Apply a suitable light cure adhesive according to the manufacturer instructions onto the cured Oxford ActiveCal PC layer and proceed with the restoration.

2. Indirect pulp capping agent in deep preparations

2.1. Cavity Preparation
After isolation (best with a rubber dam) prepare the cavity. Remove all infected carious tooth structure. Leave the preparation visibly moist.

2.2. Application
Apply the Oxford ActiveCal PC directly onto the area close to the pulp and extend Oxford ActiveCal PC 1 mm onto dentine surrounding. In case of layers more than 1 mm light cure each layer separately.
Due to the high opacity of Oxford ActiveCal PC light cure each increment 40 seconds by using a polymerization unit (wavelength range 400-500 nm) with a light intensity of at least 1000mW/cm2.
Apply a suitable light cure adhesive according to the manufacturer instructions onto the cured Oxford ActiveCal PC layer and proceed with the restoration.